If a loose or broken door armrest is encountered at the attaching screw locations, the condition may be repaired as follows:
1. Using a flat-bladed tool, carefully remove the courtesy lamp assembly from the door armrest as shown in Figure 1.
2. Remove the two (2) screws that are used to retain the armrest to the inner panel.
3. Fabricate a metal bracket to the shape of the template shown in Figure 2.
4. Check the fit of the bracket to the armrest.
5. Clean the plastic surface of the armrest with naphtha or equivalent.
6. Mix 3M structural adhesive (part number 8101 or equivalent) according to the manufacturer's directions on the package and apply it to the inboard attaching surface of the armrest and the contacting surface of the repair bracket.
7. Postion the repair bracket to the armrest and install both of the attaching screws.
8. Repeat the above repair procedure to the other armrest attaching location, if required.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.