Circuit Description
This diagnostic test checks for the absence of serial data from the EBTCM. This data is needed for misfire diagnosis (DTC P0300).
Conditions for Running the DTC
DTC P0300 is set and is requesting the MIL ON.
Conditions for Setting the DTC
No serial data is received from the EBTCM for 1.6 seconds out of the last 2 seconds.
Action Taken When the DTC Sets
| • | The Malfunction Indicator Lamp (MIL) will not illuminate. |
| • | No message will be displayed. |
Conditions for Clearing the DTC
| • | A History DTC will clear after forty consecutive warm-up cycles with no failures of any non-emission related diagnostic test. |
| • | A Last Test Failed (current) DTC will clear when the diagnostic runs and does not fail. |
| • | Use a scan tool to clear DTCs. |
| • | Interrupting PCM battery voltage may or may not clear DTCs. This practice is not recommended. Refer to Clearing Diagnostic Trouble Codes in PCM Description and Operation. |
Diagnostic Aids
If this DTC is set along with DTC P0300, it may represent an invalid misfire due to a loss of rough road data.
Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table.
-
If this DTC is set current, refer to ABS diagnosis and diagnose any EBTCM related (ABS/TCS) DTCs before diagnosing any PCM DTCs. If no EBTCM DTCs are present, perform the ABS System Check
-
If this DTC is history, check for any current or history EBTCM DTCs and diagnose those before diagnosing any PCM DTCs.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Powertrain On-Board Diagnostic (OBD) System Check? | -- | ||
Has the DTC failed? | -- | Go to Diagnostic System Check for EBTCM system diagnosis | ||
Check the EBTCM system for any history ABS/TCS DTCs or system problems. Were any DTCs or problems noted? | -- | Go to Diagnostic System Check for EBTCM system diagnosis | Fault not present |
