GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1998 🢒 Seville 🢒 Restraints 🢒 Seat Belts 🢒 Rear Seat Belt Buckle Replacement

Removal Procedure

Notice: To prevent possible seat belt damage, refer to the following items before servicing or replacing lap and shoulder belts, including single loop belt systems:

   • Lap and shoulder belts will be serviced as follows:
      - Replace only the part in question.
      - Do not intermix standard and deluxe belts on front or rear seats.
      - All attachment hardware must be replaced, not reused.
   • Keep sharp edges and damaging objects away from belts.
   • Avoid bending or damaging any portion of the belt buckle or latch plate.
   • Do not bleach or dye belt or strap webbing. Clean with a mild soap solution and water.
   • When installing lap or shoulder belt anchor bolts, start the bolts by hand to ensure that the bolts are threaded straight.
   • Do not attempt repairs on lap or shoulder belt retractor mechanisms to lap belt retractor covers. Replace defective assemblies with new service replacement parts.
   • Do not attempt to remove the seat belt retractor cover. The cover and the long rivet securing the cover to the retractor are not available as service replacement parts.


    Object Number: 291176 Size: SH
  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
  2. Remove the rear seat center belt and RH rear seat buckle anchor bolt.
  3. Slide the RH rear seat buckle anchor plate out from under the RH rear seat back hold-down.
  4. Remove the RH rear seat buckle.

Installation Procedure

    Object Number: 291176 Size: SH
  1. Install the RH rear seat belt buckle anchor plate under the RH rear seat back hold-down.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Important: Assure that the bolt threads and bolt hole are free of any sealer patch material.

  2. Install the rear seat center belt and RH rear seat buckle anchor bolt. Ensure the center belt anchor is facing rearward and the center buckle anchors are facing frontward.

    3. Tighten
    Tighten the rear seat center belt and RH rear seat buckle anchor bolt to 41 N·m (30 lb ft).

  3. Ensure the seat belt buckles are stowed in the seat back pockets and install the rear seat cushion. Refer to Rear Seat Cushion Rear Seat Cushion Replacement in Seats.