GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1998 🢒 Seville 🢒 Restraints 🢒 SIR 🢒 Parking Brake Lever Pedal Assembly Replacement

Removal Procedure
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 492729 Size: SH
  2. Ensure the park brake pedal is in the full returned position.
  3. Pull down on the front cable in relieve tension on the cable.
  4. Remove the cable from the cable connector (1).

    5. Object Number: 106200 Size: SH
  5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle
  6. Remove left sound insulator panel to access the lever assembly. Refer to Instrument Panel Insulator Panel Replacement in Insrtument Panel, Gauges, and Console.
  7. Pull back the carpet to expose the parking brake cable and lever assmembly.
  8. Remove the grommet from the flooor pan.

    9. Object Number: 107329 Size: SH
  9. Remove the parking brake assembly attaching nuts (1,2).
  10. Remove the parking brake padal assembly from the vehicle.

Installation Procedure

    Object Number: 107329 Size: SH
  1. Install the paking brake assembly to the mounting studs.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the lever attaching nuts (1,2).

    3. Tighten
    Tightn the park brake attaching nut to 24 (18lb ft ).

  3. Install the cable and grommet into the floor pan.

    4. Object Number: 492729 Size: SH
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Reconnect the front cable (3) to the rear cable (2).
  6. Lower the vehicle.

    7. Object Number: 107329 Size: SH
  7. If installing a new parking brake pedal assembly, remove the cable tensioner release pin to adjust the cable tension.
  8. Reposition the carpet.
  9. Install the left sound insulator. Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gauges, and Console.