Instrument Cluster Trim Panel Replacement LHD

1. Remove IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
2. Remove two fasteners, one on each side of the cluster.
3. Disconnect left (1) and right (2) DIC switch electrical connectors.
4. Rotate IP cluster trim (3) rearward from the top and lift out of IP retainer.
5. Remove the left and right drivers information center switches. Refer to Driver Information Display Switch Replacement .

1. Install the DIC switches to the IP cluster trim panel. Refer to Driver Information Display Switch Replacement .



2. Slide lower edge of IP cluster trim plate down behind woodgrain trim.
3. Reconnect the two electrical connectors ( 1 and 2) to DIC switches.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the two fasteners from trim panel to IP retainer.

Tighten
Tighten the IP cluster trim panel fasteners to 2 N·m (18 lb in).

5. Install IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .