Intermittent failures in electronic systems may be very difficult to detect and accurately diagnose. The modules test for different malfunctions under different vehicle conditions. Perform a thorough test drive in order to detect a repeating fault condition. If the system malfunction is not repeated during the test drive, a good description of the complaint may be useful in locating an intermittent malfunction.

Faulty wires or connections cause most intermittent conditions. When an intermittent condition is suspected, inspect the suspected circuits for the following conditions:

History DTCs indicate that the modules have previously detected a malfunction. The reason may be either that the malfunction is intermittent or that the system for which the DTC is set for is not currently being operated. For example, the rear defogger circuit does not operate until the modules detect engine RPM. For this reason, if a module displays history DTCs and the malfunction cannot be found easily, try clearing the DTCs and manually operating the system that the DTC applies to using a scan tool. Read the Diagnostic Aids and Conditions for Setting the DTC in each DTC table for more specific information.

History DTCs help in diagnosing intermittent fault conditions but may not indicate a faulty module. The module contains reliable components. The components are not a likely cause of the malfunction. Most system complaints are linked to faulty wiring and connectors, and occasionally to a component. Perform a thorough inspection of all of the related wiring and connectors pertaining to the history DTC that is stored.

The following conditions may result in intermittent module operation with no DTCs stored: