Removal Procedure
Notice: To prevent possible seat belt damage, refer to the following items before
servicing or replacing lap and shoulder belts, including single loop belt
systems:
• Lap and shoulder belts will be
serviced as follows: - Replace only the part in question. - Do not intermix standard and deluxe
belts on front or rear seats. - All attachment hardware
must be replaced, not reused. • Keep sharp edges and damaging objects away from belts. • Avoid bending or damaging any portion of the belt buckle
or latch plate. • Do not bleach or dye belt or strap
webbing. Clean with a mild soap solution and water. • When installing lap or shoulder belt anchor bolts, start the bolts by hand
to ensure that the bolts are threaded straight. • Do not attempt repairs on lap or shoulder belt retractor mechanisms to lap
belt retractor covers. Replace defective assemblies with new service replacement
parts. • Do not attempt to remove the seat belt retractor
cover. The cover and the long rivet securing the cover to the retractor are
not available as service replacement parts.
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
- Remove the rear seat center belt anchor bolt.
- Disengage the center belt escutcheon from the rear shelf panel.
- Flip the rear seat center belt up on the rear shelf panel to expose the retractor anchor bolt.
- Remove the rear seat center belt retractor anchor bolt.
- Remove the rear trim panel. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
- Remove the rear compartment trim panel to access the rear seat center belt retractor. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
- Remove the rear seat center belt through the rear compartment.
Installation Procedure
- From the rear compartment, feed the rear seat center belt anchor plate and belt through opening in the rear shelf panel.
- Install the rear seat center retractor on to the cross car beam. Ensure the retainer tab engages the notch in the beam.
- From inside the vehicle, install the rear seat center shoulder retractor bolt.
- Install the rear seat center belt escutcheon to the rear shelf opening.
- Install the rear seat center belt lower bolt. Ensure the belt anchor is facing forward.
- Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
- Install the rear trim panel. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
- Ensure the seat belt buckles are stowed in the seat back pockets and install the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the rear seat center shoulder retractor bolt to 30 N·m
(22 lb ft).
Important: Assure that the bolt threads and bolt hole are free of any sealer patch material, and that the belt is not twisted.
Tighten
Tighten the rear seat center belt bolt to 41 N·m (30 lb ft).
