For 1990-2009 cars only
Circuit Description
This diagnostic test checks for the loss of or invalid Platform Zone Module (PZM) serial data to the PCM. When such a condition exists for 11 seconds DTC P1610 is set.
Conditions for Running the DTC
DTC P0322 is not set.
Conditions for Setting the DTC
| • | Ignition switch ON for 5 seconds and PCM not receiving PZM data. |
| OR |
| • | PCM unable to communicate with the PZM for at least 11 seconds. |
Action Taken When the DTC Sets
| • | The Malfunction Indicator Lamp (MIL) will not illuminate. |
| • | No message will be displayed. |
Conditions for Clearing the DTC
| • | A History DTC will clear after forty consecutive warm-up cycles with no failures of any non-emission related diagnostic test. |
| • | A Last Test Failed (current) DTC will clear when the diagnostic runs and does not fail. |
| • | Use a scan tool to clear DTCs. |
| • | Interrupting PCM battery voltage may or may not clear DTCs. This practice is not recommended. Refer to Clearing Diagnostic Trouble Codes in Powertrain Control Module Description . |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Powertrain On-Board Diagnostic (OBD) System Check? | -- | Refer to PZM System Check |
