Tools Required

1. Remove the control arm from the vehicle. Refer to Rear Axle Lower Control Arm Replacement .
2. Remove the bushing from control arm using tools as follows:

•	Assemble the long bolt J 21474-27 with the thrust bearing through the bushing remover J 41014-1 through the bushing receiver J 41014-2 over the bushing against the control arm..

•	Lubricate the bolt threads with high pressure lubricant.

•	Install the nut J 21474-4 and begin tightening the nut.

3. Tighten the nut until the bushing is driven out of the control arm.
4. Disassemble the tools.
5. Remove the bushing.

Tools Required

1. Begin installing the bushing into the control arm ensuring that the flat on the bushing is vertical and rearward or forward.

•	Assemble the long bolt J 21474-27 with the washer through the bushing installer J 41014-1 over the bushing against the control arm.

•	Lubricate the bolt threads with a high pressure lubricant.

•	Install the bushing receiver J 21474-5 (large end facing bushing), thrust bearing and nut onto the bolt.

2. Tighten the nut until the busing is into the control arm and the bushing is fully seated.
3. Disassemble the tools and remove the tools.
4. Install the control arm. Refer to Rear Axle Lower Control Arm Replacement .