Tools Required

J 24319-01 Universal Steering Linkage Puller

1. Remove the cotter pin (2) and the hex slotted nut (1) from the outer tie rod assembly.



2. Loosen the jam nut (2) on the inner tie rod assembly (1).
3. Remove the outer tie rod assembly (2) from the steering knuckle (1) using J 42188 .



4. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

1. Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).



2. Connect the outer tie rod assembly (2) to the steering knuckle (1).



3. Install the cotter pin (2) into the hole in the tie rod stud.

Important: Be sure the rack and pinion boot is not twisted or puckered during toe adjustment.

4. Adjust the toe alignment. Refer to Front Toe Adjustment in Wheel Alignment.

Tighten
Tighten the jam nut against the outer tie rod to 75 N·m (55 lb ft).