Removal Procedure
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
- Remove the rear seat belt and buckle anchor bolt.
- Slide the rear seat buckle anchor plate out from under the rear seat back hold-down.
- Remove the rear seat belt buckles.
Installation Procedure
- Install the rear seat belt buckle anchor plates under the rear seat back hold-down.
- Install the rear seat center belt and RH rear seat buckle anchor bolt. Ensure the center belt anchor is facing rearward and the center buckle anchors are facing towards then front.
- Ensure the seat belt buckles are stowed in the seat back pockets and install the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Important: Assure that the bolt threads and bolt holes are free of any sealer patch material.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the rear seat center belt and rear seat buckle anchor bolts
to 41 N·m (30 lb ft).
