Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check or Wiper/Washer System Check

1. Disconnect the harness connector from the wiper motor.
2. Turn the ignition to RUN.
3. Set the wiper switch to HI.
4. Connect a test light from the wiper motor connector (harness side), terminal D, to ground.

Is the test light on?

--

Go to Step 3

Go to Step 6

1. Turn the ignition OFF.
2. Remove the wiper motor cover. Refer to Wiper Motor Cover Replacement . Observe the position of wiper motor cover terminal T1.
3. Connect a jumper from the wiper motor housing to ground.
4. Connect a fused jumper (10 amp) from battery voltage to the wiper motor terminal that connects to wiper motor cover terminal T1.

Did the wiper motor operate?

--

Go to Step 4

Go to Step 5

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--

Replace the wiper motor. Refer to Windshield Wiper Motor Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--

Inspect for an open in CKT 92.

Is an open present?

--

Go to Step 7

Go to Step 8

Repair the open in CKT 92.

Is the repair complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--

Replace the wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--