Mode Valve Actuator Replacement LHD

1. Remove the IP carrier. Refer to Instrument Panel Carrier Replacement in Instrument Panel, Gauges and Console.
2. Remove the driver air mix actuator retaining screws (1).



3. Remove the driver air mix actuator.



4. Remove the mode actuator retaining screws (1).
5. Remove the mode actuator.

1. Align the mode valve levers with the cam slots.
2. Install the mode actuator.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the mode actuator retaining screws (1).

Tighten
Tighten the fasteners to 1.2 N·m (12 lb in).




4. Install the driver air mix actuator.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the driver air mix retaining screws (1).

Tighten
Tighten the fasteners to 1.2 N·m (12 lb in).

6. Install the IP carrier. Refer to Instrument Panel Carrier Replacement in Instrument Panel, Gauges and Console.

Mode Valve Actuator Replacement RHD

1. Remove the IP carrier. Refer to Instrument Panel Carrier Replacement in Instrument Panel, Gauges and Console.
2. Remove the electrical connector from the passenger air mix actuator.
3. Remove the passenger air mix actuator retaining screws (1).



4. Remove the passenger air mix actuator.



5. Remove the mode actuator retaining screws (1).
6. Remove the mode actuator electrical connector.
7. Remove the mode actuator.

1. Install the mode actuator.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the mode actuator retaining screws (1).

Tighten
Tighten the fasteners to 1.2 N·m (12 lb in).

3. Install the mode actuator electrical connector.



4. Install the passenger air mix actuator.



5. Install the passenger air mix actuator retaining screws (1).
6. Install the electrical connector to the passenger air mix actuator.
7. Install the IP carrier. Refer to Instrument Panel Carrier Replacement in Instrument Panel, Gauges and Console.