Front Side Door Window Regulator Replacement for Cadillac Seville 1999

1. Remove the door trim panel. Refer to Door Trim Panel Replacement .
2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .

Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

3. Loosen the regulator window clamp bolts.
4. Manually move the glass to the up position and hold in place with tape.
5. Remove the 5 retainer bolts (1, 2).
6. Disconnect the electrical connector from the window regulator motor.



7. Remove the window regulator (1) from the door.

1. Install the window regulator (1) into the door.
2. Locate the two captive bolts (2) into the keyhole slots in the door panel.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the 3 remaining window regulator bolts in order to secure the regulator.

Tighten
Tighten the bolts to 9 N·m (80 lb in).

4. Install the window to the windows clamps.

Tighten
Tighten window clamp retaining bolts to 11 N·m (98 lb in).

5. Connect the electrical connector to the window regulator motor.
6. Install the water deflector. Refer to Front Side Door Water Deflector Replacement
7. Install the door trim panel. Refer to Door Trim Panel Replacement