Windshield Wiper Transmission Replacement LHD
Tools Required
ā¢ | J 39232 Wiper
Linkage Separator |
ā¢ | J 39529 Wiper
Linkage Installer |
Removal Procedure
- Remove the wiper arm and
blade assemblies. Refer to
Windshield Wiper Arm Replacement
.
- Remove the air inlet screen. Refer to
Air Inlet Grille Panel Replacement
in Body Front End.
- Remove the transmission drive link socket from the wiper motor
crank arm using the J 39232
.
Important: Rotate the transmission as necessary to extract from the plenum.
- Remove six screws and the transmission from the vehicle.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the transmission
on the vehicle with six screws.
Tighten
Tighten the screws to 8 NĀ·m (70 lb in).
- Install the transmission
drive link socket to the wiper motor crank arm ball using the J 39529
. Ensure that the socket is fully seated
on the ball.
- Install the air inlet screen. Refer to
Air Inlet Grille Panel Replacement
in Body Front End.
- Install the wiper arm and blade assemblies. Refer to
Windshield Wiper Arm Replacement
.