GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2002 🢒 Seville 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T80-E 🢒 Control Valve Body Assembly Replacement

Removal Procedure
  1. Remove the bottom pan and seal, scavenge screens, and the lip seals. Refer to Transfer Oil Pump Inlet Screen and Pipe Seal Replacement .

    2. Object Number: 792054 Size: SH
  2. Remove the bolts from the oil transfer plate and the wire harness extension retaining clip.
  3. Remove the oil transfer plate.

    4. Object Number: 792055 Size: SH
  4. Disconnect the wire harness extension from the wire harness assembly.

    5. Object Number: 792057 Size: SH

    Important: Do not reuse the retainer (2), it must be replaced.

  5. Use a small screwdriver in order to disconnect the manual valve link retainer (2) from the manual valve link (3).

    6. Important: Do not pry the internal mode switch assembly.

  6. Remove the manual valve link (3) from the inside detent lever (1).

    7. Object Number: 791424 Size: SH
  7. Remove the two nuts and fourteen bolts from the lower valve assembly.
  8. Remove the lower valve assembly (consisting of the channel plate, control valve body, accumulator assembly, and wire harness extension) from the transaxle case as a single unit.
  9. For disassembly of the lower control valve body assembly. Refer to Control Valve Lower Body Disassemble in Automatic Transaxle - 4T80-E Unit Repair Manual.

Installation Procedure
  1. For reassembly of the lower control valve body assembly. Refer to Lower Control Valve Body and Transmission Fluid Pressure Switch Install in Automatic Transaxle - 4T80-E Unit Repair Manual.

    2. Object Number: 791424 Size: SH
  2. Install the lower valve assembly (consisting of the channel plate, control valve body, accumulator assembly, and the wire harness extension) to the transaxle case as a single unit.
  3. Place the Lower valve assembly over the forward support studs.
  4. Hand start the bolts and nuts to the lower valve assembly.

    5. Object Number: 792054 Size: SH
  5. Install the oil transfer plate.
  6. Position the wire harness extension retaining clip over the appropriate bolt hole in the oil transfer plate.

    7. Notice: Refer to Fastener Notice in the Preface section.

  7. Hand start the bolts to the oil transfer plate.

    8. Tighten
    Tighten the Lower valve assembly and the oil transfer plate bolts and nuts to 11 N·m  (97 lb in).


    Object Number: 792057 Size: SH

    Important: Do not reuse retainer (2), it must be replaced.

  8. Insert the manual valve link (3) into the inside detent lever (1).

    9. Clip the manual valve link retainer (2) onto the manual valve link (3).


    Object Number: 792055 Size: SH
  9. Connect the wire harness extension to the wire harness assembly.
  10. Install the bottom pan and seal, the scavenger screens, and the lip seals. Refer to Transfer Oil Pump Inlet Screen and Pipe Seal Replacement .

    11. Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  11. Reset the TAP values. Refer to Adapt Function .