Tools Required
⢠| J 42578 Steering
Wheel Puller Legs |
Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
⢠| Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
⢠| Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
⢠| If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in
SIR.
- Remove the inflatable restraint steering wheel module (SIR). Refer
to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
- Remove the steering wheel retaining nut.
- Disconnect the steering wheel electrical connector.
- Install J 1859-A
and J 42578
to the steering wheel.
- Using J 1859-A
and J 42578
separate the
steering wheel from steering shaft.
- Remove the steering wheel.
Installation Procedure
- Install the steering wheel.
- Align the steering wheel with the mark on the steering shaft.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install steering
wheel retaining nut.
Tighten
Tighten the steering wheel nut to 41 NĀ·m (30 lb ft).
- Connect the steering wheel electrical connector.
- Install the SIR module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.