For 1990-2009 cars only
Removal Procedure
- Starting at the rear of the door, split the foam tape using a braided wire or a flat-bladed tool inserted between the molding and the sheet metal. If using a flat-bladed tool, protect the surrounding surfaces. Do not damage the paint.
- Remove the door molding from the door.
- Clean the old adhesive from the door and from any reusable molding with 3M General Purpose Adhesive Cleaner 08984 or equivalent.
Installation Procedure
- If the molding is being reused, apply new adhesive tape to the molding.
- Align the molding using the locator pins.
- Remove the backing from the tape.
- Align and press the molding to the door. Apply heavy hand pressure against the molding, rubbing along the entire length of the molding.
Important: Wear clean gloves or use a clean towel while performing this step.
