Diagnostic System Check - Wiper/Washer. Cadillac Seville 2002

For 1990-2009 cars only

Makes 🢒 Cadillac 🢒 2002 🢒 Seville 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Diagnostic System Check - Wiper/Washer

Test Description

The numbers below refer to the step numbers on the diagnostic table.

Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

Turn ON the ignition, with the engine OFF.
Attempt to establish communication with the following modules:

•	Dash integration module (DIM)

•	Instrument Panel Cluster (IPC)

Does the scan tool communicate with the systems listed?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.

Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool.
Rotate the ignition switch through all positions while observing the Class 2 Power Mode parameter.

Does the Class 2 Power Mode parameter reading match the ignition switch position for all switch positions?

Go to Step 4

Go to Power Mode Mismatch in Body Control System

Select the display DTCs function on the scan tool for the following control modules:

•

DIM

•

IPC

Does the scan tool display any DTCs?

Go to Step 5

Go to Symptoms - Wiper/Washer Systems

Does the scan tool display any DTCs which begin with a "U"?