Parking Brake Release Solenoid Replacement LHD

1. Remove left closeout/insulator panel to access the park brake lever assembly. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panels, Gages and Console.
2. Pull back the carpet to expose the park brake cable and lever assembly.



3. Remove the park brake lever assembly mounting nuts (1, 2).
4. Position the park brake pedal assembly away from the mounting studs.



5. Disconnect the electrical connector from the park brake warning lamp switch.



6. Disconnect the electrical connector from the automatic park brake release solenoid (2).
7. Remove the automatic park brake release solenoid mounting bolt (1).
8. Remove the automatic park brake release solenoid (2) from the park brake lever assembly.

1. Install the automatic park brake release solenoid (2) to the park brake lever assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the park brake release solenoid mounting bolt (1).

Tighten
Tighten the automatic park brake release solenoid mounting bolt to 24 N·m (18 lb ft).

3. Connect the electrical connector to the automatic park brake release solenoid (2).



4. Connect the electrical connector to the park brake warning lamp switch.



5. Install the park brake lever assembly to the mounting studs.
6. Install the park brake lever assembly mounting nuts (1, 2).

Tighten
Tighten the park brake lever assembly mounting nut to 24 N·m (18 lb ft).

7. Reposition the carpet.
8. Install the left colseout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panels, Gages and Console.

Parking Brake Release Solenoid Replacement RHD

1. Remove right closeout/insulator panel to access the park brake lever assembly. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panels, Gages and Console.



2. Disconnect the electrical connector from the park brake warning lamp switch.



3. Disconnect the electrical connector from the automatic park brake release solenoid (2).
4. Remove the automatic park brake release solenoid mounting bolt (1).
5. Remove the automatic park brake release solenoid (2) from the park brake lever assembly.

1. Install the automatic park brake release solenoid (2) to the park brake lever assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the park brake release solenoid mounting bolt (1).

Tighten
Tighten the automatic park brake release solenoid mounting bolt to 24 N·m (18 lb ft).

3. Connect the electrical connector to the automatic park brake release solenoid (2).



4. Connect the electrical connector to the park brake warning lamp switch.
5. Install the right closeout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panels, Gages and Console.