Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the left front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the left front fascia extension. Refer to Front Bumper Fascia Extension Replacement in Bumpers.
- Remove the 2 brake pressure modulator valve (BPMV) bracket nuts (2).
- Remove the 3 BPMV bracket to frame bolts (2).
- Remove the BPMV bracket (1) from the frame (3).
Installation Procedure
- Install the BPMV bracket (1) to the frame (3).
- Install the 3 BPMV bracket to frame bolts (2).
- Install the EBCM/BPMV assembly (1) to the BPMV bracket (3).
- Install the 2 BPMV bracket nuts (2).
- Install the left front fascia extension. Refer to Front Bumper Fascia Extension Replacement in Bumpers.
- Install the left front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 bolts to 10 N·m (89 lb in).
Important: Make sure that all 3 rubber isolators are installed on the BPMV. The isolators protect the EBCM/BPMV assembly from vehicle vibrations.
Tighten
Tighten the 2 nuts to 10 N·m (89 lb in).
