GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gages, and Console.

  2. Object Number: 291754  Size: SH
  3. Unsnap the shift cable terminal from the shifter pin.
  4. Remove the shift cable bolt and cable from the shifter.

  5. Object Number: 291741  Size: SH
  6. Disconnect the automatic transmission shift lock actuator wire harness connector, from the automatic transmission shift lock actuator solenoid.
  7. Disengage the locking tab on the park lock cable and lift the cable out of the slot in the shifter.
  8. Unhook the park lock cable from the park lock cam on the shifter.

  9. Object Number: 291888  Size: SH
  10. Remove the shifter fasteners.
  11. Spread the console side panels apart and remove the shifter assembly.

Installation Procedure


    Object Number: 291888  Size: SH
  1. Spread the console side panels apart and install the shifter assembly.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the shifter fasteners.
  4. Tighten
    Tighten the shifter fasteners to 9 N·m (79 lb in).


    Object Number: 291741  Size: SH
  5. Insert the park lock cable into the park lock cam on the shifter.
  6. Slide the park lock cable into the shifter and assure that the cable locking tab is fully engaged.
  7. Connect the automatic transmission shift lock actuator wire harness connector.

  8. Object Number: 291754  Size: SH
  9. Snap the shift cable terminal onto the shifter pin.
  10. Fasten the shift cable to the shifter.
  11. Tighten
    Tighten the shift cable bolt to 25 N·m (18 lb ft).

  12. Adjust the shift cable as follows.
  13. 8.1. Place the shifter into the N (neutral) position.
    8.2. Loosen the shifter adjuster nut.
    8.3. Tighten the adjuster nut.

    Tighten
    Tighten the adjuster nut to 25 N·m (18 lb ft).

  14. Install the console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gages and Console.