Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .
2. Remove the upper filler panel. Refer to Filler Panel Replacement - Upper in Body Front End.
3. Disconnect the discharge hose from the condenser.
4. Raise and support vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Remove the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.



6. Disconnect the discharge hose from the compressor.
7. Disconnect the electrical connector from the A/C refrigerant pressure sensor.
8. Remove the discharge hose.

Important: Inspect the sealing washers for damage.

1. Install the discharge hose.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Connect the discharge hose to the compressor.

Tighten
Tighten the discharge hose to 20 N·m (15 lb ft).

3. Connect the electrical connector to the A/C refrigerant pressure sensor.
4. Lower the vehicle.



5. Connect the discharge line to the condenser.

Tighten
Tighten the accumulator line fitting to 20 N·m (15 lb ft).

6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
7. Leak test the fittings of the repaired or reinstalled component using J 39400-A .
8. Install the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.
9. Install the upper filler panel. Refer to Filler Panel Replacement - Upper in Body Front End.