| Table 1: | IPC Scan Tool Output Controls |
| Table 2: | IPM Scan Tool Output Controls |
| Table 3: | PCM Scan Tool Output Controls |
| Table 4: | Rear Integration Module (RIM) Scan Tool Output Controls |
Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
Displays Test | Output Control | The scan tool displays Commanded State: None, Off or On. When you select ON, all segments of the HVAC control module (IPM), IPC, and radio should illuminate for 5 seconds, and all gauges should sweep through their full range of motion. When you select OFF, all segments of the IPM, IPC, and radio should be blank, and all gauges should be at zero for 5 seconds. |
Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
A/C Request | Miscellaneous Test | The scan tool displays Commanded State: None, Off, or On. This function allows you to turn the A/C request ON or OFF for 5 seconds. |
Air Inlet Door Position | HVAC Motors | The scan tool displays Outside or Recirc selections. This function drives the actuator to its minimum (ambient air) or maximum (recirculate) stops for 20 seconds. |
Blower Motor | Miscellaneous Test | The scan tool displays Commanded State: None, Off, or On. This function allows you to command the blower motor to its maximum (100%) or minimum (0%) speeds for 5 seconds. |
Htr./Def./A/C Door Position | HVAC Motors | The scan tool displays Upper or Defrost positions. This function drives the actuator to its minimum (defrost) or maximum (upper) positions for 20 seconds. |
Instant OAT Update | Miscellaneous Test | The scan tool displays Commanded State: None, Off, or On. This function updates the IPM ambient air temperature input to the current raw value. |
IPM Recalibration | Miscellaneous Test | The scan tool displays: Commanded State: None or On. Selecting ON will update the IPM with the latest software calibration. |
Left Temp Door Position | HVAC Motors | The scan tool displays Hot or Cold selections. The selection drives the actuator to its minimum (cold) or maximum (hot) positions for 20 seconds. |
Recalibrate Motors | Miscellaneous Test | The scan tool displays Commanded State: None or On. This functions commands all actuators to their fully opened and fully closed positions, and relearns these endpoints. |
Right Temp Door Position | HVAC Motors | The scan tool displays Hot or Cold selections. The selection drives the actuator to its minimum (hot) or maximum (cold) positions for 20 seconds. |
Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
A/C Relay | Engine Output Controls | The scan tool displays ON or OFF selections. This command allows you to turn the A/C compressor relay ON or OFF. When commanded OFF, the relay should remain OFF until commanded ON. When commanded ON, the relay should remain ON for 5 seconds. When the A/C compressor relay is commanded ON, the A/C compressor clutch should be engaged. |
Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
Rear Blower Power Relay | Output Control | The scan tool displays Commanded State: None, Off or On. This function allows you to command the auxiliary blower motor relay ON or OFF for 5 seconds. |
