For 1990-2009 cars only
Removal Procedure
- Remove the rear seat back and disconnect the rear seat back pass through release cable (1). Refer to Rear Seat Back Replacement in Seats.
- Remove the tie strap securing the rear seat pass thorough release cable (1) to the seat back.
- Remove the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.
- Remove the nut (1) from the seat pass thorough release handle.
- Remove the seat pass thorough release cable (2) and handle from the electrical component mounting panel (1).
- Remove the cable housing (1) from the release handle housing (2) and slide the cable out of the lever in the handle.
- Remove the release handle from the cable (1).
Installation Procedure
- Install the seat pass thorough release cable (1) to the slot in the lever on the release handle (2).
- Snap the cable housing to the release cable handle housing.
- Install the pass thorough release cable (2) and handle through the opening in the electrical component mounting panel (1).
- Partially install the rear seat back.
- Connect the rear seat back pass through release cable (1).
- Tie strap the pass through release cable (1) to the seat frame.
- Install the rear seat back. Refer to Rear Seat Back Replacement in Seats.
- Install the release handle to the body.
- Install the release handle nut (1).
- Install the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nut to 9 N·m (80 lb in).
