GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2004 🢒 Seville 🢒 Accessories 🢒 Entertainment 🢒 Memory Seat Control Module Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.


    Object Number: 669311 Size: SH
  1. Disable the SIR. Refer to SIR Disabling and Enabling or to SIR Disabling and Enabling in SIR.
  2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
  3. Remove the front seat cushion assembly fasteners (1), at the rear of the seat cushion.

    4. Object Number: 669309 Size: SH
  4. Adjust the front seat assembly to the rear of the vehicle.
  5. Angle the front seat cushion (1) up, in order to access the front seat cushion assembly fasteners (2).
  6. Remove the front seat cushion assembly fasteners (2).
  7. Lift the front seat cushion assembly (1) away from the seat riser.

    8. Important: The heated seat cushion cover connectors and several wire hold down clips will need to be removed in order to position the seat cushion against the seat back.

  8. Position the seat cushion assembly (1) against the seat back, in order to access the memory seat module rivets and the electrical connector.

    9. Object Number: 295290 Size: SH
  9. Disconnect the memory seat module electrical connector.

    10. Object Number: 669304 Size: SH

    Caution: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.

    Important: Cover the seat motors and cables in order to avoid metal shavings in the mechanism.

  10. Drill out the rivets (3) retaining the memory seat module (4) to the seat cushion frame.
  11. Remove the memory seat module (4).
  12. Calibrate the seat. Refer to Memory Seat Calibration .

Installation Procedure

    Object Number: 669304 Size: SH
  1. Install the memory seat module (4) to the seat cushion frame.
  2. Install the new rivets (3) to the memory seat module (4) in order to secure the memory seat module to the seat cushion frame.

    3. Object Number: 295290 Size: SH
  3. Connect the electrical connector to the memory seat module.
  4. Connect the heated seat cushion cover electrical connectors and the wire hold down clips which were removed during disassembly.

    5. Object Number: 669309 Size: SH
  5. Remove the protective cover from the seat riser.
  6. Install the seat cushion assembly (1) to the seat riser.

    7. Notice: Refer to Fastener Notice in the Preface section.

  7. Install the fasteners (2) to the seat cushion assembly (1).

    8. Object Number: 669311 Size: SH
  8. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
  9. Install the front seat cushion assembly rear fasteners (1) to the seat cushion assembly.

    10. Tighten
    Tighten the seat cushion assembly fasteners to 9 N·m (80 lb in).

  10. Angle the front seat cushion up, in order to access the front seat cushion assembly fasteners.

    11. Tighten
    Tighten the seat cushion assembly fasteners to 9 N·m (80 lb in).

  11. Enable the SIR. Refer to SIR Disabling and Enabling or SIR Disabling and Enabling in SIR.