Circuit Description
The first design digital radio antenna is connected to the digital radio receiver by 2 coax cables. One coax carries the satellite signal, the other coax carries the terrestrial signal. The antenna cable for the satellite antenna also provides a path for D.C. current for powering the antenna. The second design digital radio antenna is connected to the digital radio receiver by 1 coax cable. This coax carries the satellite and the terrestrial signal.
Conditions for Running the DTC
This test is run every 300 milliseconds.
Conditions for Setting the DTC
The digital radio receiver detects an antenna fault.
Action Taken When the DTC Sets
The radio displays "No XM Signal."
Conditions for Clearing the DTC
The condition must be corrected.
Test Description
The number below refers to the step number on the diagnostic table.
-
First design has 2 antenna cables connected to the digital radio receiver, second design has 1 antenna cable.
-
Early design modules support the mV reading while later design modules support the mA reading.
-
Due to current limiting capabilities in the module, an antenna cable shorted to ground could still show 1200-1800 mV.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Radio/Audio System Schematics Connector End Views Reference: Entertainment Connector End Views | ||||
1 | Did you perform the Radio/Audio System Diagnostic System Check? | -- | Go to Step 2 | |
Does the digital radio receiver have 2 antenna cables? | Go to Step 3 | Go to Step 4 | ||
With a scan tool, observe the digital radio antenna in the digital radio receiver data list. Does the scan tool indicate that the digital radio antenna is within the specified range? | 1200-1800 mV or 42-118 mA | Go to Step 5 | Go to Step 6 | |
4 | With a scan tool, observe the digital radio antenna in the digital radio receiver data list. Does the scan tool indicate that the digital radio antenna is within the specified range? | 17-63 mA | Go to Step 9 | Go to Step 6 |
Test the antenna cables for a short to ground. Refer to Circuit Testing in Wiring Systems. Did you find the condition? | -- | Go to Step 8 | Go to Step 11 | |
6 |
Does the voltage measure within the specified range? | 4.5-5.5 V | Go to Step 7 | Go to Step 9 |
7 | Test the antenna cables for an open or high resistance. Refer to Circuit Testing in Wiring Systems. Did you find the condition? | -- | Go to Step 8 | Go to Step 11 |
8 | Replace the antenna cables. Refer to Digital Radio Antenna Cable Replacement . Did you complete the replacement? | -- | Go to Step 13 | -- |
9 | Inspect for poor connections at the digital radio receiver. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 10 |
10 |
Important: Always perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup Replace the digital radio receiver. Refer to Digital Radio Receiver Replacement . Did you complete the replacement? | -- | Go to Step 13 | -- |
11 | Inspect for poor connections at the digital radio antenna. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 12 |
12 | Replace the digital radio antenna. Refer to Digital Radio Antenna Replacement . Did you complete the replacement? | -- | Go to Step 13 | -- |
13 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
