GM Service Manual Online
For 1990-2009 cars only

Use the scan tool data values under the following conditions:

    • The Diagnostic System Check - Automatic Transmission is complete.
    • The On-Board Diagnostics are functioning properly.
    • No DTCs are present.

The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:

    • Engine at idle
    • Upper radiator hose hot
    • Closed throttle
    • Transmission in Park
    • Closed Loop operation
    • Accessories OFF
    • Brake pedal not applied

Transmission Scan Tool Data List

Scan Tool Parameter

Data List*

Units

Typical Data Value

1-2 Shift Error

F2,F6/F0

Seconds

Varies

1-2 Shift Time

F0,F2,F6/F0

Seconds

Varies

1-2 Sol.

F0,F2,F3,F4

On/Off

On

1-2 Sol. CKT Status

F2

OK, Open/Short to GND, Short to Volts

Varies

1-2 TAP Cell 4-16

F6/F0

kPa (psi)

Varies

2-3 Shift Error

F3,F6/F1

Seconds

Varies

2-3 Shift Time

F0,F3,F6/F1

Seconds

Varies

2-3 Sol.

F0,F2,F3,F4

On/Off

Off

2-3 Sol. CKT Status

F3

OK, Open/Short to GND, Short to Volts

Varies

2-3 TAP Cell 4-16

F6/F1

kPa (psi)

Varies

3-4 Shift Error

F4,F6/F2

Seconds

Varies

3-4 Shift Time

F0,F4,F6/F2

Seconds

Varies

3-4 TAP Cell 4-16

F6/F2

kPa (psi)

Varies

A/C Clutch

F0

On/Off

Off

Commanded Gear

F0,F1,F2,F3,F4,F5

1, 2, 3, 4

1

Cruise

F0

Disabled/Enabled

Disabled

Current Tap Cell

F6/F0,F6/F1,F6/F2

4-16

Varies

ECT

F0,F1

°C (°F)

Varies

Engine Run Time

F0

hours:minutes:seconds

Varies

Engine Speed

F0,F1,F2,F3,F4,F5

RPM

600-700 RPM

Engine Torque

F0,F1

N·m (lb ft)

27-34 N·m (20-25 lb ft)

Gear Ratio

F0,F1,F2,F3,F4

0.00

3.98

Ignition Voltage

F0

Volts

12.6-14.7

IMS

F0

Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, Invalid

Park

IMS A/B/C/P

F0

HI/LOW

LOW/HI/HI/LOW

Last Shift Time

F0

Seconds

Varies

PC Sol. Actual Current

F0,F5

Amps

0.94-1.06 amps

PC Solenoid Duty Cycle

F0,F5

%

Varies

PC Sol. Ref. Current

F0,F5

Amps

0.94-1.06 amps

Steady State TAP 1GR

F6/F3

kPa (psi)

Varies

Steady State TAP 2GR

F6/F3

kPa (psi)

Varies

Steady State TAP 2GR/TCC

F6/F3

kPa (psi)

Varies

Steady State TAP 3GR

F6/F3

kPa (psi)

Varies

Steady State TAP 3GR/TCC

F6/F3

kPa (psi)

Varies

Steady State TAP 4GR

F6/F3

kPa (psi)

Varies

Steady State TAP 4GR/TCC

F6/F3

kPa (psi)

Varies

Steady State TAP Reverse

F6/F3

kPa (psi)

Varies

TCC Brake Switch

F0,F1

Open/Closed

Closed

TCC Duty Cycle

F0,F1

%

0%

TCC Duty Cycle CKT Status

F1

OK, Open/Short to GND, Short to Volts

Varies

TCC Slip Speed

F0,F1

RPM

Varies

TFP Sw. Sig. A/Sig. C

F0

HI/LOW

HI/HI

TP Angle

F0,F1,F2,F3,F4,F5

%

0%

TP Sensor

F0,F1,F2,F3,F4

Volts

0.00 volts

Trans. Fluid Temp.

F0,F1,F5

°C (°F)

Varies

Trans. Oil Life

F0

%

Varies

Transmission Hot Mode

F0,F1

On/Off

Off

Transmission ISS

F0,F1,F2,F3,F4

RPM

600-700 RPM

Transmission OSS

F0,F1,F2,F3,F4

RPM

0

Vehicle Speed

F0,F1,F2,F3,F4

km/h (mph)

0

*Data List Legend

    • F0: Transmission Data
    • F1: TCC Data
    • F2: 1-2 Shift Data
    • F3: 2-3 Shift Data
    • F4: 3-4 Shift Data
    • F5: PC Solenoid Data
    • F6/F0: Transmission Adapts/1-2 Adapt. Data
    • F6/F1: Transmission Adapts/2-3 Adapt. Data
    • F6/F2: Transmission Adapts/3-4 Adapt. Data
    • F6/F3: Transmission Adapts/Steady State Data