The Park Brake System uses a pair of solenoids to set or release the park brake pedal. These solenoids are powered by relays which are commanded ON and OFF by the body control module (BCM). When the gear shift lever is taken out of Park or Neutral, the BCM simultaneously activates both solenoids to release the park brake pedal. Solenoid A is deactivated after 2 seconds and solenoid B remains activated until the gear shift lever is in Park or Neutral, the engine is OFF, and the park brake switch is closed.
This diagnostic procedure supports the following DTC:
DTC C0291 Park Brake Release Relay Circuit
This vehicle has DTCs that include DTC Symptoms. For more information on DTC Symptoms, refer to DTC Symptom Description in Vehicle DTC Information.
DTC Symptom | DTC Symptom Descriptor |
---|---|
02 | Short to Ground |
05 | Short to Battery or Open |
• | The ignition is ON. |
• | Ignition voltage is greater than 8 volts. |
The BCM detects park brake relay A circuit is shorted to ground.
The BCM detects one of the following conditions:
• | The park brake relay A circuit is shorted to battery. |
• | The park brake relay A circuit is open. |
The Antilock Brake System (ABS) indicator turns ON.
• | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
• | The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
The park brake relay A circuit is shorted to ground.
Possible causes of this DTC are the following conditions:
• | The park brake relay A circuit is shorted to voltage. |
• | The park brake relay A circuit is open. |
The numbers below refer to the step numbers on the diagnostic table.
Tests the park brake release relay control circuit for power.
Tests for open in park brake release relay ground circuit.
Tests for open, short to ground or short to B+ in park brake release relay control circuit.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Park Brake System Schematics | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
Did test light come ON? | Go to Step 3 | Go to Step 4 | |
Check for open in relay A ground circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and repair condition? | Go to Step 7 | Go to Step 5 | |
Check for open, short to ground or short to B+ in park brake relay coil 1 control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct condition? | Go to Step 7 | Go to Step 6 | |
5 | Replace park brake release relay. Did you complete replacement? | Go to Step 7 | -- |
6 | Replace body control module (BCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete replacement? | Go to Step 7 | -- |
7 | Clear DTCs, then operate the park brake. Does the park brake release? | System OK | Go to Step 2 |