Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems | |||
1 | Did you perform the Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Place the hazard switch in the OFF position. Do the hazard lamp remain ON continuously? | Go to Step 6 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
3 | Disconnect the hazard switch. Do the hazard lamps turn off? | Go to Step 4 | Go to Step 6 |
4 | Test for a short to ground in the hazard switch input circuit. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | -- |
5 |
Important: Perform the setup procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems. Replace the BCM. Refer to Body Control Module Replacement in Computer/Integrating Systems. Did you complete the replacement? | Go to Step 7 | -- |
6 | Replace the hazard warning switch. Refer to Hazard Warning Switch Replacement Did you complete the repair? | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
