GM Service Manual Online
For 1990-2009 cars only

Circuit Description

This internal vehicle information communication system (VICS) memory test in internal to the navigation radio.

Conditions for Running the DTC

The navigation radio tests the VICS memory when it detects a power mode transition to ON.

Conditions for Setting the DTC

    • The navigation radio determines there is an internal error in the radio.
    • Diagnostic trouble code (DTC) B2466 does not set if DTC B1328 or B1327 is current.

Action Taken When the DTC Sets

    • Last VICS information is displayed if requested.
    • Limited or no VICS information is used in route guidance.
    • VICS switch may not be displayed on the screen.
    • This failure has no effect outside the navigation system.

Conditions for Clearing the DTC

A current DTC will clear when the navigation radio does not detect the failure during the last power mode transition.

Diagnostic Aids

Cycle the ignition switch even after a successful inspection with a scan tool in order to initialize the system.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Determines if the malfunction is present.

  2. Verifies that the DTC sets under normal operating conditions.

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle In Vehicle DTC Information

2

  1. Turn OFF the ignition.
  2. Disconnect the scan tool.
  3. Open, then close driver door to cancel retained accessory power (RAP).
  4. Important: Do not operate any vehicle system for one minute.

  5. Connect a scan tool.
  6. Turn ON the ignition with engine off.
  7. Retrieve diagnostic trouble codes (DTCs) from the navigation radio.

Does the DTC reset?

Go to Step 3

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

3

Replace the navigation radio. Refer to Radio Replacement in Entertainment.

Did you complete the replacement?

Go to Step 4

--

4

  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle according to the Conditions for Running the DTC in the supporting text.

Does the DTC reset?

Go to Step 2

System OK