Schematic Reference: Power Window Schematics and Door Control Module Schematics

Connector End View Reference: Power Door Systems Connector End Views

Did you perform the Vehicle Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the passenger door power window is inoperative.

Does the passenger door power window operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With a scan tool, command the front psgr. window motor Up and Down.

Does the front psgr. window go Up and Down with each command?

Go to Step 4

Go to Step 8

1. With a scan tool, observe the drvr. RF window switch parameter in the Driver Door Module data list.
2. Activate the drvr. RF window switch Up and Down.

Does the scan tool display Up and Down for the drvr. RF window switch parameter?

Go to Step 5

Go to Step 9

1. With a scan tool, observe the front psgr. window switch parameter in the Passenger Door Module data list.
2. Activate the front psgr. window switch Up and Down.

Does the scan tool display Up and Down for the front psgr. window switch parameter?

Go to Step 10

Go to Step 6

Test the passenger door switch ground circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 7

Test the power window motor front passenger signal circuits for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 10

Inspect for poor connections at the harness connector of the passenger door module (PDM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 11

Inspect for poor connections at the harness connector of the driver door switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 12

Inspect for poor connections at the harness connector of the passenger window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 13

1. Perform the power window reinitialization procedure. Refer to Power Window Reinitialization
2. Replace the passenger door module (PDM). Refer to Door Control Module Replacement .

Did you complete the replacement?

Go to Step 14

--

Replace the driver door switch. Refer to Front Door Switch Replacement .

Did you complete the replacement?

Go to Step 14

--

Replace the passenger window switch. Refer to Front Side Door Window Switch Replacement - Right Side .

Did you complete the replacement?

Go to Step 14

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2