Left Side Harness Connections
- Disconnect the engine wiring harness from the left side
fuel injectors.
- Disconnect the engine wiring harness from the left camshaft
cover.
- Disconnect the engine wiring harness
from the left ignition coil harness.
- Disconnect the engine wiring harness from the left camshaft
position sensors.
- Disconnect the engine wiring harness from the EVAP purge solenoid.
- Disconnect the engine wiring harness from the throttle
position sensor on the throttle body.
- Remove the nut attaching the starter motor wiring harness to the generator stud.
- Disconnect the starter motor wiring harness from the generator stud.
- Disconnect the engine wiring harness from the generator.
- Disconnect the engine wiring harness from the oil pressure sensor.
- Disconnect the engine wiring harness from the oxygen
sensor wiring harness.
- Disconnect the engine wiring harness from the starter
motor wiring harness.
- Remove the bolt and nut retaining the engine wiring
harness to the engine block.
- Remove the engine wiring harness ground bolt at the front of the engine block.
- Remove the engine wiring harness ground bolt at the rear of the engine block.
- Remove the bolt retaining the engine wiring harness to the left camshaft position
actuator housing.
Right Side Harness Connections
- Disconnect the engine wiring harness from the right
side fuel injectors.
- Disconnect the engine wiring harness from the right
camshaft cover.
- Disconnect the engine wiring harness
from the right ignition coil harness.
- Disconnect the engine wiring harness
from the right camshaft position sensors.
- Remove the engine wiring harness ground nut from the fuel rail stud.
- Remove the engine wiring harness ground from the fuel rail stud.
- Disconnect the engine wiring harness from the ECT sensor at the rear of the right
cylinder head.
- Disconnect the engine wiring harness from the air conditioning compressor.
- Disconnect the engine wiring harness from the MAP sensor.
- Disconnect the engine wiring harness
from the knock and crankshaft position sensor wiring harness.
- Disconnect the engine wiring harness from the oil level
sensor.
- Disconnect the engine wiring harness from the right
oxygen sensor wiring harness.
- Remove the engine wiring harness bracket bolt from the
engine block.
- Remove the engine wiring harness from the engine.