- Remove the ECT sensor from the rear of the right cylinder head.
- Remove the knock and crankshaft position
sensor wiring harness bolt (1).
- Disconnect the knock and crankshaft position sensor wiring harness connectors from the knock sensors and the crankshaft position sensor.
- Disconnect the knock and crankshaft position sensor wiring harness from the attaching points in the center, back and front of block valley.
- Remove the knock and crankshaft position
sensor wiring harness.
- Loosen the knock sensor bolts.
- Remove the knock sensors.
- Remove the crankshaft position sensor bolt.
- Remove the crankshaft position sensor.
- Remove and discard the crankshaft position sensor O-ring.
- Remove the starter motor bolts.
- Remove the starter motor and starter motor wiring harness.