Tools Required
J 41623-B Cooler Quick Connect
Tool
Removal Procedure
- Install the J 41623-B
onto the generator cooling inlet pipe.
- Slide the J 41623-B
toward the generator cooling inlet pipe fitting.
Important: Rotate the J 41623-B
to
engage the generator cooling inlet pipe fitting's retainer slots.
The J 41623-B
should be
nearly flush with the fitting.
- Connect the J 41623-B
onto
the generator cooling inlet pipe fitting.
- Rotate the J 41623-B
until the retainer clip (1) rises above the fitting retainer seat.
- Pull back on the generator cooling inlet
pipe to disengage the pipe from the generator cooling inlet pipe fitting.
- Remove the J 41623-B
from the generator cooling inlet pipe.
Installation Procedure
Important: Inspect the generator cooling inlet pipe fitting and retaining clip for signs
of wear or damage. Replace the components if necessary.
- Install the generator cooling inlet pipe into the generator cooling inlet pipe
fitting.
A distinct snap should be heard or felt when assembling the generator cooling
inlet pipe to the fitting.
- To ensure the cooler line is properly installed, give the cooler pipe
a gentle pull.