GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 38185 Hose Clamp Pliers

Removal Procedure

  1. Drain the cooling system. Refer to Cooling System Draining and Filling .
  2. Remove the air outlet duct in order to gain access to the thermostat housing. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 4.6L (LH2).

  3. Object Number: 1201091  Size: SH
  4. Remove the heater hose from the thermostat housing using a J 38185 .
  5. Remove the coolant radiator hose from the thermostat housing. Refer to Coolant Bypass Hose Replacement .
  6. Remove the thermostat housing bolts.
  7. Remove the thermostat housing with thermostat from the engine front cover.
  8. Remove the thermostat and seal ring and discard the seal ring.

Installation Procedure


    Object Number: 1201091  Size: SH
  1. Install a new seal ring on the thermostat.
  2. Install the thermostat and new seal ring into the thermostat housing.
  3. Install the thermostat housing with the thermostat assembly to the engine front cover.
  4. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the thermostat housing bolts.
  6. Tighten
    Tighten the thermostat housing bolts to 20 N·m (15 lb ft).

  7. Position the radiator hose over to the thermostat housing and reposition the clamp using the J 38185 .
  8. Install the heater hose to the thermostat housing using J 38185 .
  9. Install the air outlet duct. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 4.6L (LH2).
  10. Fill the cooling system. Refer to Cooling System Draining and Filling .