Removal Procedure
- Remove the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
.
- Disconnect the ignition coil wiring harness electrical connector from the coil that is being replaced.
- Remove the ignition coil retaining bolt.
- Remove the ignition coil.
Installation Procedure
Important: Ensure that the spark plug seal is in place when installing the ignition coil.
- Install the ignition coil.
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition coil retaining bolt.
Tighten
Using the installation torque sequence, tighten the ignition module retaining bolts to 10 N·m (89 lb in).
- Reconnect the ignition coil electrical connector.
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
.