GM Service Manual Online
For 1990-2009 cars only

Step

Action

Values

Yes

No

Connector End View Reference: Engine Control Module Connector End Views in Engine Controls - 4.6L (LH2) or Power and Grounding Connector End Views in Wiring Systems

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

Start the engine.

Does the battery charge indicator remain illuminated?

--

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

3

  1. Install a scan tool
  2. With a scan tool, observe the Battery 1 parameter in the body control module (BCM) data list.

Does the voltage measure within the normal operating range?

10.5-17.5 V

Go to Step 4

Go to Charging System Test

4

With a scan tool, command the lamp and gages On and Off.

Does the charge indicator turn On and Off with each command?

--

Go to Step 5

Go to Step 6

5

Replace the engine control module (ECM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 7

--

6

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 7

--

7

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2