Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide
alternate support to avoid the possibility of damage to the vehicle or personal
injury.
- Open and support the hood.
- Release the clip retaining the hood assist rod (2) to the lower assist rod ball stud (1).
Notice: Apply pressure only at the end of the liftgate/hood
assist rod that you are removing or attaching. Do NOT apply pressure to the middle
of the rod because damage or bending will result.
- Release the clip retaining the hood assist rod (2) from the upper assist rod ball stud attached to the hood (3).
- Remove the hood assist rod (2) from the vehicle.
Installation Procedure
- Install the hood assist rod (2) to the vehicle.
- Install the hood assist rod (2) onto the upper hood assist rod ball stud attached to the hood (3).
- Install the hood assist rod (2) onto the lower hood assist rod ball stud (1).
- Insure that both clips are fully seated on the hood assist rod (2).
- Close the hood.