Removal Procedure
- Open the rear compartment.
- Remove the rear compartment lid inner trim panel. Refer to
Rear Compartment Lid Inner Panel Trim Replacement
.
- Disconnect the electrical connector (1) from the back up lamp assembly wiring harness inside of the rear compartment lid.
- Remove the plastic wing nuts (5) attaching the back up lamp (3) to the rear compartment lid.
- Remove the back up lamp (3) from the rear compartment lid.
- Remove the back up lamp bulb/sockets (4) from the back up lamp. Refer to
Backup Lamp Bulb Replacement
.
Installation Procedure
- Install the back up lamp bulb/sockets (4) to the back up lamp. Refer to
Backup Lamp Bulb Replacement
.
Important: Ensure the rubber grommet (2) attached to the back up lamp wiring harness is properly installed and sealed, in order to avoid water intrusion into the rear compartment and chafing of the wiring harness.
- Postion the back up lamp (3) to the rear compartment lid.
- Install the back up lamp wing nuts (5).
- Connect the electrical connector (1) to the back up lamp wiring harness inside of the rear compartment lid.
- Inspect the back up lamp for proper operation.
- Install the rear compartment lid trim panel. Refer to
Rear Compartment Lid Inner Panel Trim Replacement
.
- Close the rear compartment.