Important: The power windows will not work properly if the battery on the vehicle has been disconnected, or loses power with the door open and the window down. The window switch door module must be reinitialized once power is restored. Follow these steps to reinitialize the module, and restore proper function to the windows, and switches.

Door Module Initialization Procedure

1. Close the door.
2. Raise the window by holding the up arrow on the power window switch.
3. Hold the up arrow for three seconds after the window is closed.
4. Release the switch.
5. Hold the up arrow again for three seconds.

Keep in mind that nothing can be obstructing the window from closing or opening. If you continue the initialization, the window will only Express-Up or Express-Down, to the spot where the obstruction occurred. The Express features will not work until the system has been reinitialized.

Window Adjustment - Door

1. Raise the window.

Caution: Refer to Battery Disconnect Caution in the Preface section.

2. Disconnect the battery.



3. Remove the door trim panel. Refer to Door Trim Panel Replacement .



4. Remove the mastic sealer from the window clamp access holes.
5. Loosen the window clamp bolts.
6. Jiggle the window to break the window loose from the clamps rubber seals. Verify that the rubber inserts are not dislodged, or stuck on the window glass.



7. Note the imprinted reference mark on the glass. Position the mark to the trailing edge of the rearmost clamp on the window regulator.



8. Apply masking tape to the leading (1), and top edges (2) of the outer window glass.
9. Place a mark on the leading edge tape (1) 8 mm (0.3 in) from the top of the glass.
10. Place a mark on the top edge masking tape (2) 10 mm (0.4 in) from the top of the glass.
11. Adjust the window using one of the following methods:

•	Put a socket on the clamp bolt and use the socket to move the window.

1.	Adjust the window forward or rearward first.

2.	Adjust the front height second.

3.	Adjust the rear height last.

•	Sit in the vehicle with the door closed and with the aid of an assistant standing outside of the vehicle, position the window in the door opening.

1.	Adjust the window forward or rearward first.

2.	Adjust the front height second.

3.	Adjust the rear height last.




12. Slide the window in the window clamps as necessary.

•	The glass should penetrate the leading seal (1) 8 mm (0.3 in).

•	The glass should penetrate the top seal at (2) and (3) 10 mm (0.4 in).

•	The gap should be evenly spaced at (4) and (5).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

13. Tighten the window clamps.

Tighten
Tighten the window regulator window clamp bolts to 16 N·m (12 lb ft).




14. Install new mastic sealer to the window clamp access holes.
15. Open the door and carefully guide the glass past the seals.
16. Install the door trim panel. Refer to Door Trim Panel Replacement .

Caution: Refer to Battery Disconnect Caution in the Preface section.

17. Reconnect the battery.
18. Lower the door glass and perform door module reprogramming after closing the door.
19. To perform minor height and minor tip-in adjustments. Refer to Door Window Tip-In Adjustment and Door Window Minor Height Adjustment .