For 1990-2009 cars only
Removal Procedure
- Remove the seat. Refer to Seat Replacement in Seats.
- Remove the door manual release actuator. Refer to Door Inside Manual Release Actuator Replacement in Doors.
- Remove the door sill trim plate. Refer to Carpet Retainer Replacement .
- Remove the accelerator pedal stop bracket.
- Remove the driver foot rest.
- Pull the carpet from under the I/P and accessory trim plate. The graphic shows the driver side; the passenger side is similar.
- Pull the carpet from under both sides of the center console.
- Pull the carpet down and out from the bottom of the rear window trim panel.
- Pull the seat electrical connector down through the carpet
- Remove the carpet.
Installation Procedure
- Position the carpet over the floor.
- Pull the electrical connector up through the carpet
- Tuck the carpet under the accelerator pedal.
- Tuck the carpet under the bottom of the rear window trim panel.
- Tuck the carpet under both sides of the console.
- Install the accelerator pedal stop.
- Install the driver side foot rest.
- Tuck the carpet under the I/P and accessory trim plate.
- Install the side sill trim plate. Refer to Carpet Retainer Replacement .
- Install the door manual release actuator. Refer to Door Inside Manual Release Actuator Replacement in Doors.
- Install the seat. Refer to Seat Replacement in Seats.
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the stop nuts to 10 N·m (89 lb in).
Tighten
Tighten the foot rest nuts to 10 N·m (89 lb in).
