GM Service Manual Online
For 1990-2009 cars only

Caution: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.

Removal Procedure


    Object Number: 1111822  Size: SH
  1. Manually open the folding top as shown in the illustration. Refer to Folding Top Manual Operation .
  2. Remove the trim panel retainer from the folding top headliner. Refer to Folding Top Headlining Trim Panel Retainer Replacement .

  3. Object Number: 1331056  Size: SH
  4. Remove the retaining screws at the rear of the folding top roof panel.
  5. Remove the side trim panel retainer from the folding top headliner. Refer to Folding Top Headlining Trim Panel Side Retainer Replacement .
  6. Lower the headliner from the folding top panel.
  7. Disconnect the electrical connector to the intrusion sensor, if equipped.
  8. Remove the headliner assembly.

Installation Procedure


    Object Number: 1331056  Size: SH
  1. Install the headliner to the vehicle.
  2. Connect the electrical connector to the intrusion sensor.
  3. Install the headliner to the folding top panel.
  4. Install the side trim panel retainer to the folding top headliner. Refer to Folding Top Headlining Trim Panel Side Retainer Replacement .
  5. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the retaining screws at the rear of the folding top roof panel.
  7. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  8. Install the trim panel retainer to the folding top headliner. Refer to Folding Top Headlining Trim Panel Retainer Replacement .
  9. Manually close the folding top. Refer to Folding Top Manual Operation .