For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
- Remove the left front lower wheelhouse splash shield fasteners (1, 2, 3) at the rear of the wheelhouse.
- Disconnect the output hose (4) from the washer pump, and drain the contents into a suitable container.
- Disconnect the electrical connector (3) from the washer pump.
- Remove the washer pump by twisting the pump out of the washer solvent container.
Important: Ensure that the hoist is clear of the left front fender, to allow the lower fender to be moved away from the body for clearance.
Important: Note the position of the fender for installation alignment.
Installation Procedure
- Install the washer pump rubber grommet into the washer solvent container.
- Lubricate the pump body and grommet with washer fluid to aid in installation.
- Insert the pump body through the grommet until the pump is seated as originally positioned.
- Connect the electrical connector (3) to the washer pump.
- Connect the washer pump output hose (4) to the washer pump.
- Lower the vehicle.
- Refill the washer solvent container.
- Inspect the operation of the pumps and level sensor, also for leaks.
- Align the fender to the body, and install the left front lower wheelhouse splash shield and fasteners (1, 2, 3).
- Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
