GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Open the hood.

  2. Object Number: 929138  Size: SH
  3. Disconnect the washer pump hose (5) from the driver side air inlet grille.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Important: Ensure that the hoist is clear of the left front fender, to allow the lower fender to be moved away from the body for clearance.

  6. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .

  7. Object Number: 929129  Size: SH

    Important:  Note the position of the fender for alignment during installation.

  8. Remove the left front lower wheelhouse splash shield fasteners (1, 2, 3) at the rear of the wheelhouse.

  9. Object Number: 929131  Size: SH

    Important: When replacing the washer output hose from the cowl grille to the pump, route the hose down towards the washer container, ensuring that the hose rubber grommet is seated in the pass-through hole in the body.

  10. Disconnect the washer pump output hose (4) by twisting the hose away from the washer pump.

Installation Procedure


    Object Number: 929131  Size: SH
  1. Connect the washer pump outlet hose (4) to the pump (3).
  2. Lower the vehicle.

  3. Object Number: 929138  Size: SH
  4. Connect the upper washer hose connection (5)at the air inlet grille.
  5. Inspect the operation of the pumps and the level sensor, and for leaks.

  6. Object Number: 929129  Size: SH
  7. Align the lower fender to the body, and install the lower wheelhouse splash shield and fasteners (1, 2, 3).
  8. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .