GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Refer to SIR Caution in the Preface section.


    Object Number: 754855  Size: SH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Remove the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  3. Disconnect the electrical connectors for the steering wheel control switch.

  4. Object Number: 803006  Size: SH
  5. Remove the steering wheel control switch retaining screws.
  6. Remove the steering wheel control harness retainer and screw.
  7. Carefully pull the steering wheel control switch assembly away from the steering wheel in order to release the steering wheel control switch assembly from the steering wheel.
  8. Remove the steering wheel control switch assembly from the steering wheel.
  9. Remove the wire harness from the steering wheel control switch assembly.

Installation Procedure

  1. Install the wire harness to the steering wheel control switch assembly.

  2. Object Number: 803005  Size: SH
  3. Align the steering control switch assembly engagement tabs to the steering wheel.
  4. Push in on the steering wheel control switch assembly in order to secure the control switch assembly to the steering wheel.


    Object Number: 803006  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the steering wheel control harness retainer and screw.
  6. Tighten
    Tighten the screw to 2.3 N·m (20 lb in).

  7. Install the steering wheel control switch assembly screws.
  8. Tighten
    Tighten the screws to 2.3 N·m (20 lb in).


    Object Number: 754855  Size: SH
  9. Connect the steering wheel control electrical connector.
  10. Secure the connector to the retaining clip.
  11. Install the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  12. Enable the SIR. Refer to SIR Disabling and Enabling in SIR.