Removal Procedure
Important: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.
- Remove the rear compartment stowage trim. Refer to
Body Rear Compartment Replacement.
- Remove the 3 retaining nuts to the digital radio receiver from the mounting bracket.
- Lower the receiver from the mounting bracket and disconnect the coaxial and the electrical leads from the receiver.
- Remove the radio receiver from the vehicle.
Installation Procedure
- Position the digital radio receiver to the vehicle and connect the coaxial and the electrical leads to the receiver.
Notice: Refer to Fastener Notice in the Preface section.
- Install the receiver to the mounting bracket and install 3 retaining nuts.
Tighten
Tighten the nuts to 9 N·m (80 lb in).
- Remove the rear compartment stowage trim. Refer to
Body Rear Compartment Replacement.
- Perform the setup procedure for the digital radio receiver. Refer to
Control Module References for programming and setup information.