GM Service Manual Online
For 1990-2009 cars only

Circuit Description

When the content theft deterrent (CTD) system arms, and the intrusion sensor is enabled, the body control module (BCM) receives a power-up acknowledgement from the intrusion sensor via the intrusion sensor armed signal circuit.

DTC Descriptor

This diagnostic procedure support the following DTC:

DTC B3089 Intrusion Sensor Armed Signal Circuit

DTC Symptom

DTC Symptom Descriptor

00

No Power-up Acknowledgement Received By BCM

Conditions for Running the DTC

The BCM monitors the intrusion sensor armed signal circuit whenever the CTD system arms, and the intrusion sensor is enabled.

Conditions for Running the DTC

    • The intrusion sensor is enabled.
    • The CTD system has armed.

Conditions for Setting the DTC

The BCM does not receive the power-up acknowledgement from the intrusion sensor.

Action Taken When the DTC Sets

The BCM will ignore all inputs from the intrusion sensor for the remainder of the CTD system arming cycle.

Conditions for Clearing the MIL/DTC

DTC B3089 will be cleared if any of the following occur:

    • The BCM receives a power-up acknowledgement from the intrusion sensor during the next CTD system arming cycle, and the intrusion sensor is enabled.
    • Use the scan tool to clear DTCs.

Step

Action

Yes

No

Schematic Reference: Theft Deterrent System Schematics

Connector End View Reference: Theft Deterrent System Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Verify that DTC B3089 is set.

Is DTC B3089 set as current?

Go to Intrusion Sensor Inoperative

Go to Testing for Intermittent Conditions and Poor Connections