Removal Procedure
- Remove the instrument panel knee bolster trim panel. Refer to
Driver Knee Bolster Panel Replacement
in Instrument Panel,
Gages, and Console.
- Disconnect the accelerator pedal position sensor (1)
and brake apply sensor (2).
- Remove the retainer, washer, brake booster
pushrod, and brake pedal pin from the brake pedal.
- Reposition the isolation mat by cutting a small slit in the mat.
- Remove the brake pedal pivot bolt and nut.
- Remove the brake pedal from the mounting bracket.
Installation Procedure
- Lubricate the bushings, pivot bolt, and all friction parts with high temperature
silicone brake lubricant.
- Install the brake pedal to the mounting bracket.
Notice: Refer to Fastener Notice in the Preface section.
- Install the pivot bolt and nut.
Tighten
Tighten the brake pedal pivot nut to 29 N·m (21 lb ft).
- Reposition the dash isolation mat.
- Install the retainer, washer, brake booster
pushrod, and brake pedal pin to the brake pedal. Verify proper engagement of the retainer
to the brake pedal pin by rotating the retainer.
- Connect the accelerator pedal position sensor (1)
and brake apply sensor (2).
- Install the instrument panel knee bolster trim panel. Refer to
Driver Knee Bolster Panel Replacement
in Instrument Panel,
Gages, and Console.