GM Service Manual Online
For 1990-2009 cars only

Scan Tool Output Control

Additional Menu Selections

Description

Column Calibration

Calibrate

The DPM can be commanded by using the scan tool to calibrate the tilt/telescope steering wheel. This must be done every time the DPM or the tilt/telescope actuators are replaced.

Column Lock Relay

On/Off

The BCM can be commanded by using the scan tool to energize the column lock enable circuit.

Default Position

Recall/Cancel

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the default position.

Memory 1 Exit Position

Recall/Cancel

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 1 exit position in the DPM memory.

Memory 1 Position

Recall/Cancel

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 1 position in the DPM memory.

Memory 2 Exit Position

Recall/Cancel

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 2 exit position in the DPM memory.

Memory 2 Position

Recall/Cancel

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 2 position in the DPM memory.

SCLCM Setup

--

The SCLCM can be commanded by the scan tool to be programmed to the installed vehicle. The module will then only work on the vehicle that it was programmed. This procedure is only necessary when installing a new module.

Telescope Motor

Forward/Rearward

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel forward or rearward.

Tilt Motor

Up/Down

The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel up or down.